Temperature and Humidity Acquisition Module

This acquisition module translates physical temperature and humidity into data your monitoring software can actually use. It is built around a Swiss-made sensor element and a 32-bit MCU that handles signal processing and protocol conversion on the same board. Power consumption stays under 10 mA during measurement, so a small solar panel and battery can keep it running for years in remote landslide sites. The aluminum alloy enclosure with a sintered filter protects the sensor from dust and water spray while allowing air exchange—important for fast humidity response. On the communication side, you get RS485 with Modbus RTU as standard; analog 4–20 mA outputs are available on request. Multiple units can be connected on a single bus using screw terminals, eliminating the need for junction boxes in distributed arrays. Kingmach ships every module with a signed calibration certificate traceable to national standards, and we store the calibration coefficients inside the module’s memory. This means any data logger or SCADA system that reads the Modbus registers automatically gets compensated values, no manual entry. For projects requiring hundreds of nodes, Kingmach’s global distribution and local technical support keep lead times short—usually 4 weeks for standard configurations, with faster turnaround for rush orders through our regional partners. Because we manufacture in-house, we can also adjust filter housings, cable glands, or output scaling to match your specific geotechnical application, whether it’s concrete curing, slope stability, or dam seepage monitoring.